I have a question for you all about decals. As you may or may not have noticed I am currently building the WNW D.Va and the scheme has a number of decals covering the empennage area (tail). My problem is that the decals overlap the edge but I want them to join over the edges. To do this I need to wrap the decals around a sharp corner and then trim them. The trimming bit SHOULD be OK. I can't just sand them off as the tail is painted yellow and I would have to repaint all the edges.
SO my question is how do I get the decals to conform to the sharp corners, or is ot just a matter of cutting them off and painting the said areas?
Thank you for your attention and I eagerly await your answers .
