Any ideas ? I thought using my hobby knife to modify the corner section and then just make the intakes themselves out of plasticard ?
General Aircraft
This forum is for general aircraft modelling discussions.
This forum is for general aircraft modelling discussions.
Hosted by Jim Starkweather
Modifying F-117 intakes ?
SkunkWorks
Joined: August 08, 2013
KitMaker: 19 posts
AeroScale: 14 posts
Posted: Sunday, August 25, 2013 - 12:33 AM UTC
I have a 1/48 Italeri F-117 on the way which I'm converting into an RAF F-117C ( a proposed replacement for the typhoon at one time ) the only issue I will possibly run into with this model is modifying the gridded intakes into these as shown ...
Any ideas ? I thought using my hobby knife to modify the corner section and then just make the intakes themselves out of plasticard ?
Any ideas ? I thought using my hobby knife to modify the corner section and then just make the intakes themselves out of plasticard ?
SkunkWorks
Joined: August 08, 2013
KitMaker: 19 posts
AeroScale: 14 posts
Posted: Sunday, August 25, 2013 - 01:45 AM UTC
* REPLACEMENT FOR THE PHANTOM SORRY NOT THE TYPHOON 
*
*
 |
WEB HOSTING BY
Copyright ©2021 AeroScale and Kitmaker Network, a subsidiary of Silver Star Enterprises
All Rights Reserved. Please read our Conditions of Use and Privacy Policy.
All Rights Reserved. Please read our Conditions of Use and Privacy Policy.