Can actual Tamiya tape be applied over wing rib locations? Not as a mask but firmly
attached.
Then painted and clear coated.
Hosted by Jim Starkweather
use actual tape for wing ribs on ww1 aircraft
teak29
Florida, United States
Joined: February 08, 2013
KitMaker: 23 posts
AeroScale: 20 posts
Joined: February 08, 2013
KitMaker: 23 posts
AeroScale: 20 posts
Posted: Saturday, December 14, 2013 - 06:07 AM UTC
Jessie_C
British Columbia, Canada
Joined: September 03, 2009
KitMaker: 6,965 posts
AeroScale: 6,247 posts
Joined: September 03, 2009
KitMaker: 6,965 posts
AeroScale: 6,247 posts
Posted: Saturday, December 14, 2013 - 06:29 AM UTC
The texture may cause some difficulty depending on the scale, and making sure that it sticks down over the course of years may be a challenge.
It can be used to define rib tapes though. Put down two strips on either side of the rib and paint on some Mr Surfacer. Once it's dry, pull up the tape to reveal a nicely defined rib tape.
It can be used to define rib tapes though. Put down two strips on either side of the rib and paint on some Mr Surfacer. Once it's dry, pull up the tape to reveal a nicely defined rib tape.
teak29
Florida, United States
Joined: February 08, 2013
KitMaker: 23 posts
AeroScale: 20 posts
Joined: February 08, 2013
KitMaker: 23 posts
AeroScale: 20 posts
Posted: Saturday, December 14, 2013 - 08:15 AM UTC
Masking is very time consuming which is only one of the reasons I'm considering taping.
It would also show depth like tape because it is tape.
The edges could possibly be roughed a bit which is authentic,
as would showing some slight texture.
It would also show depth like tape because it is tape.
The edges could possibly be roughed a bit which is authentic,
as would showing some slight texture.
thegirl
Alberta, Canada
Joined: January 19, 2008
KitMaker: 6,743 posts
AeroScale: 6,151 posts
Joined: January 19, 2008
KitMaker: 6,743 posts
AeroScale: 6,151 posts
Posted: Saturday, December 14, 2013 - 08:34 AM UTC
Yes you can use Tamiya tape for doing rib tapes . Start with a gloss surface apply the tape and then seal the surface with more gloss coat . Or you can use Mr.surface 500 or 1000 sprayed on with an airbrush . Once this is fully dried lighty sand the surface with fine or even a scotch brite pad will work just the same . Paint or apply lozenge .
Terri
Terri
Jessie_C
British Columbia, Canada
Joined: September 03, 2009
KitMaker: 6,965 posts
AeroScale: 6,247 posts
Joined: September 03, 2009
KitMaker: 6,965 posts
AeroScale: 6,247 posts
Posted: Saturday, December 14, 2013 - 08:35 AM UTC
I'm interested to see how it works out. To cut a consistent width, try taping two #11 blades together with a spacer between them. If it works it'll be a significant trick in the early aviation modeller's toolbox.