General Aircraft
This forum is for general aircraft modelling discussions.
This forum is for general aircraft modelling discussions.
Hosted by Jim Starkweather
FW 190 aerial wire question
Posted: Friday, January 20, 2006 - 10:39 PM UTC
i'm just about ready to put the canopy on a 190 F8 in the open position, and i'm sure i've seen the wire slack on these aircraft when the hood was pulled back. BUT having had a look around a few sites at 190's, i have'nt seen one like that, all the wires are shown as being straight, and i'm wondering if i've gotten another plane mixed up with it
Posted: Friday, January 20, 2006 - 10:53 PM UTC
Hi Phil,
No your right it is the FW190 that can have a slack antenna wire. Don't quote me on this but I am under the impression that it depends on which hood was fitted. The square straight sided one had a taught wire, the "blown" hood had no tensioning mechanism so the wire went slack when the hood was open. It did have a spring, at the tail post, to tension the wire when closed.
My Fw190D-9 has a blown hood, if it were open the antenna wire would be slack.
Mal
No your right it is the FW190 that can have a slack antenna wire. Don't quote me on this but I am under the impression that it depends on which hood was fitted. The square straight sided one had a taught wire, the "blown" hood had no tensioning mechanism so the wire went slack when the hood was open. It did have a spring, at the tail post, to tension the wire when closed.
My Fw190D-9 has a blown hood, if it were open the antenna wire would be slack.
Mal
Posted: Friday, January 20, 2006 - 11:09 PM UTC
problem sorted! mine is definatly a "flat top" hood, so i'll get the headrest in, and get it on tonight