In-Box Review
Fiat G.55 Centauro
Fiat G.55 Centauro Sottoserie 0
  • SH_G55_Boxtop

by: Rowan Baylis [ MERLIN ]

The Fiat G.55 grew from the Italian aviation industry's scramble to produce a modern fighter able to meet its powerful and heavily-armed Allied counterparts on more-or-less equal terms. With no suitable in-line engines of their own, the German DB 601 and 605 were chosen for licence production. As with the Macchi C.205 and Reggiane Re 2005, Fiat fitted a DB 605 (or RA 1050 Tifone, as the Italian-built version was known) to an airframe developed from an existing design - in this case, the Fiat G.50 - to produce a new fighter which promised far superior performance.

The prototype flew on April 30, 1942 and immediately showed a lot of promise. Early aircraft were armed with a rather unusual configuration of weapons - 1x Mauser MG 151/20 20mm cannon firing through the propeller hub and no less than 4 x Breda-SAFAT 12.7 mm machine-guns in the nose, two each above and below the engine. Although closely spaced weapons gave a good density of fire, the arrangement proved troublesome in practice and the lower machine guns were moved to the wings where they were later replaced with a pair of additional cannons.

In trials against the C.205 and Re.2005 the Fiat G.55 proved to have the best all-round performance but, despite its promise and considerable German interest, production was pitifully slow and only 35 G.55s had been built by the time of Armistice in September 1943. Thereafter, production continued for another year under German control and 148 G.55s were delivered to the Fascist Aeronautica Nazionale Repubblicana in Northern Italy. Production could never meet demand and the A.N.R. units were forced to re-equip with Bf 109Gs, despite the Italian pilots' reluctance to accept an aircraft they felt was clearly inferior to the Fiat.

The kit
Special Hobby's new Centauro arrives in a sturdy and attractive conventional box with the clear parts bagged separately from the other sprues. The kit comprises:

73 x mid grey styrene parts
3 x clear parts
42 x etched steel parts, plus a clear film for the instrument faces
1 x Resin Part
Decals for 3 x colour schemes

The moulding is pretty good. Remember, this a semi-short run kit so the standard isn't up to the standard of mainstream producers, with a bit of flash here and there on the smaller parts and a few surface blemishes. The plastic used is quite soft, which makes it easy to polish the parts to remove any marks. Surface detail consists of nicely scribed panel lines and a few raised access panels, plus subtly depicted fabric control surfaces. I found a few minor sink marks here and there and, as you'd expect in a kit of this nature, there some hefty ejector-pin marks on the inner surfaces, including a couple in the cockpit area which require attention.

Parts Breakdown and Test Fit
The first thing that's immediately apparent is that this kit is produced with future alternative versions planned.So, you get two complete fuselages to depict the early- and late-style rudders (more on that later) and a separate nose section to allow for the different armament configurations of the Sottoserie 0 and its successors.

A test fit of the major parts is very encouraging - the fuselage halves line up well and the wings have nice thin trailing edges and match the roots well. The nose assembly is surprisingly fiddly, with separate exhaust troughs which must be aligned carefully before the upper and lower cowls can be joined. Since the cowls are split laterally and the fuselage is split vertically, you have to add the nose section as a complete unit and hope the cross-section matches. The gun ports are moulded solid, but the soft plastic will make it easy to drill them out.

The cockpit is built up from a mix of styrene and etched parts. It's a little surprising that almost no use at all is made of resin (just the gunsight), but the plastic parts aren't bad at all. Interestingly, a resin cockpit for the G.55 is available... in the more expensive Pacific Coast Models version which utilises the same sprues - and the instructions for the Special Hobby kit actually show the extra detail from the resin side-walls, so they can be used as a reference for improving the plastic parts included here.

The instrument panel is broken into three sections with etched fronts and film backing for the instrument faces. There's a plastic auxiliary panel under the dashboard, but most of the other cockpit details are etched, including a nicely done version of the distinctive Italian seat-harness.

Looking at the rest of the airframe, the wheelwells have some quite good moulded detail and the undercarriage should look fine with a little basic cleaning up. Special Hobby correctly supply the extra bulge and ejector shutes on the belly for the Sottoserie 0's lower nose guns.

The canopy is neatly moulded in one piece and is very clear, with well-defined framing. It's thin enough to look good if you choose to slice it carefully with a razor saw to pose it open.

The assembly diagrams are well drawn and break the construction down into 23 clear stages. Colour notes are keyed to the Gunze Sangyo paints range.

Important: As noted above, separate parts are included for fuselages with early- and late-style rudders, and these are numbered incorrectly in the instructions. To build the aircraft in the decal options, you should use parts A1 and A2 (not E1 and E2 as shown, which have a late-style rudder). The boxtop and painting diagrams show the correct style.

Painting and Decals
Special Hobby supply decals for 3 interesting schemes:

A. - s/n MM 91059 "12-353", 353 Squadriglia, 20 Gruppo, 51 Stormo, August 1943 in standard delivery finish.
B. - s/n MM 91074 "13", Squadriglia "Montefusco", with Luftwaffe markings overpainted and replaced by A.N.R. insignia.
C. - s/n MM 91064 "11", 1 Squadriglia "Gigi Tre Osei", 2 Gruppo, May 1944 in the spectacular experimental 3-colour topsides splinter scheme worn by the aircraft at Lonate Pozzolo.

The decals are well printed - thin and glossy and in perfect register - but my sheet has been partially spoilt by somehow being smeared before the ink had dried. Strangely, this has only happened to the blue and red fuselage numbers and some careful trimming will salvage the markings for Scheme C.

This is a very neat kit of a version of the G.55 which hasn't been available before in this scale as an injected kit. As with any short-run model, a bit of experience is recommended for anyone tackling it but, on the basis of the test fit, it seems reasonably straightforward and will build into a spectacular and unusual WW2 fighter.

Camouflage and Markings of the Aeronautica Nazionale Repubblicana 1943-1945, by Ferdinando D'Amico and Gabriele Valentini, Classic Colours, 2005

Special Hobby's Fiat G.55 Sottoserie 0 is available from Modelimex - specialists in Eastern European short run kits.

Please remember, when contacting retailers or manufacturers, to mention that you saw their products highlighted here - on AEROSCALE.
Highs: A version previously unavailable. Well moulded with good details and spectacular colour schemes.
Lows: Not recommended for beginners. Decals slightly damaged in my kit (unlikely to effect others).
Verdict: A fine kit for experienced modellers looking to add an unusual WW2 fighter to their collection.
Percentage Rating
  Scale: 1:48
  Mfg. ID: SH 48066
  Suggested Retail: € 31.00
  PUBLISHED: Jul 22, 2007

About Rowan Baylis (Merlin)

I've been modelling for about 40 years, on and off. While I'm happy to build anything, my interests lie primarily in 1/48 scale aircraft. I mostly concentrate on WW2 subjects, although I'm also interested in WW1, Golden Age aviation and the early Jet Age - and have even been known to build the occas...

Copyright 2021 text by Rowan Baylis [ MERLIN ]. Images also by copyright holder unless otherwise noted. Opinions expressed are those of the author(s) and not necessarily those of AeroScale. All rights reserved.


Camo scheme for our Nige to try I feel . Great review Rowan. Andy
JUL 22, 2007 - 05:42 AM
Hi Andy Camo scheme for me to try! - it's always been one of my favourites. All the best Rowan
JUL 22, 2007 - 06:07 AM
Very nice review Rowan. It looks like it'll take a bit of work to get together but the detail looks very good. As for that spectacular camo scheme,,,not a problem. Im pretty tempted to order one and break out the Tamiya masking tape! Nige
JUL 22, 2007 - 06:10 AM
Here you go Nige A bit of inspiration... And, no, I haven't suddenly mastered the art of building kits quickly! It's actually the Classic Airframes kit of the later G.55 version with wing cannons - and it's sat unfinished on my Shelf Of Shame for years. Having scraped the dust off it for this pic, I suppose I should see about finishing it one day... if I can remember where the rest of the parts are. According to the refs I've got since I painted it, the brown I used for the camo is really a bit too dark and too red. All the best Rowan
JUL 22, 2007 - 06:38 AM
Looks damned good though
JUL 22, 2007 - 06:46 AM
Nice job Rowan! Ive just read (while looking on Ebay,,LOL) that the Special Hobby kit is a lot better than the old Classic Airframes one. I hope the decal issue on your sample is just a one off! Your G-55 is so close to completion. What stalled this build? Modelgeek are running the perfect campaign for you! Get The Job Done for finishing half completed kits. Nige
JUL 22, 2007 - 06:49 AM
Hi Nige It's so long ago, I can't remember - but, knowing me, I just got distracted by a new kit... which I bet got left half-finished in turn (if I ever started it...)! All the best Rowan
JUL 22, 2007 - 06:56 AM
Very cool camouflage scheme - both the one Rowan has lying on a shelf somewhere and the one in the instructions. Very attractive and tempting to try out. However, it does not beat the sand/green "cloud" pattern. Thanks for the review.
JUL 22, 2007 - 08:42 PM

Click image to enlarge
  • SH_G55_Contents
  • SH_G55_Parts_A
  • SH_G55_Parts_B
  • SH_G55_Parts_C
  • SH_G55_Parts_E
  • SH_G55_Clear_Parts
  • SH_G55_Etch
  • SH_G55_Gunsight
  • SH_G55_Colour
  • SH_G55_Decals_1
  • SH_G55_Decals_2
  • SH_G55_Cowling_1
  • SH_G55_Cowling_2
  • SH_G55_Floor
  • SH_G55_Sidewall_1
  • SH_G55_Sidewall_2
  • SH_G55_Seat
  • SH_G55_Radiator_1
  • SH_G55_Radiator_2
  • SH_G55_Wheelwell
  • SH_G55_Undercarriage
  • SH_G55_Mainwheel