_GOTOBOTTOM
Rotary Wing
Discuss helicopters and other rotary wing aircraft from any era.
Hosted by Gino P. Quintiliani
Dragon 1/35 OH-6 Cayuse, "Egg", WIP
redleg12
_VISITCOMMUNITY
New Jersey, United States
Joined: March 11, 2007
KitMaker: 872 posts
AeroScale: 22 posts
Posted: Tuesday, March 31, 2009 - 12:40 AM UTC
Gino - Thanks, always great to have you drop in. Thanks for the comments.

Rounds Complete!!
mvfrog
_VISITCOMMUNITY
California, United States
Joined: August 25, 2008
KitMaker: 369 posts
AeroScale: 104 posts
Posted: Tuesday, March 31, 2009 - 12:55 PM UTC
This is beautiful. The pilots are very fine. keep on...

Matt
redleg12
_VISITCOMMUNITY
New Jersey, United States
Joined: March 11, 2007
KitMaker: 872 posts
AeroScale: 22 posts
Posted: Tuesday, March 31, 2009 - 01:52 PM UTC
Matt - Thanks for looking and for your comments.

Rounds Complete!!
SGTJKJ
#041
_VISITCOMMUNITY
Kobenhavn, Denmark
Joined: July 20, 2006
KitMaker: 10,069 posts
AeroScale: 3,788 posts
Posted: Wednesday, April 01, 2009 - 01:26 AM UTC
Great job on the egg, Mike. A great looking bird with some nice figures in it.

Thanks for sharing
redleg12
_VISITCOMMUNITY
New Jersey, United States
Joined: March 11, 2007
KitMaker: 872 posts
AeroScale: 22 posts
Posted: Wednesday, April 01, 2009 - 03:37 AM UTC
Jesper - Thanks for looking and for your comments. That's what this site is for....to share and learn. I am glad to have posted it and in that instance you are welcome.

Thanks again

Rounds Complete!!
Belt_Fed
_VISITCOMMUNITY
New Jersey, United States
Joined: February 02, 2008
KitMaker: 1,388 posts
AeroScale: 42 posts
Posted: Wednesday, April 01, 2009 - 01:17 PM UTC
I like it a lot. Especially the interior. Those microphones muct have been a real pane to make!

Can you give us a bit more details on the BDU decals?
redleg12
_VISITCOMMUNITY
New Jersey, United States
Joined: March 11, 2007
KitMaker: 872 posts
AeroScale: 22 posts
Posted: Wednesday, April 01, 2009 - 01:30 PM UTC
Sabian - First thanks for looking.

The headset mic is actually easy. It is thin gauge wire bent in an elongated U. Then I cut a small section the width of the U and slightly longer in length from blue painters tape. To assure long term stick I added a little Gator Glue. After it set up, paint black. After drying I somewhat eyeball meaure the mouth to side distance and put a bend in the assembly. Now measure to the attachment point and cut off excess and glue to the helmet. The PIA is more the size and handling.

The decals are great. Here is a link to one of my previous build where I decaled figures in the new digital pattern

https://armorama.kitmaker.net/forums/129264&page=1

There is some more detail there. If you still have questions, just pull my PM lanyard.

Hope that help. Feel free if you have more questions or details

Rounds Complete!!
 _GOTOTOP